Posted by Joe R on September 02, 2001 at 00:09:23:
In Reply to: Re: Volume matching posted by mike on September 01, 2001 at 01:53:30:
I just glanced over you post, so far the only mistake I can see is
your volume for a 72.. its capacity is rated at a 10% overfil not at 2250
so at 2250 you have only roughly 65 ft3
There is an easier way to calculate turn PSI/BAR,
I teach it in my Tech classes.. I'll try and write up an explanation if I
can get sometime.. I rather not do it on the fly
it involves calculating a baseline for each size cylinder.