Posted by Chuck Tribolet on January 12, 2005 at 12:42:54:
In Reply to: Lowering Intermediate Pressure posted by Second Fiddle on January 12, 2005 at 12:35:20:
You can get a painter's pressure reg from any big
HW store for about $20. It will knock the 150 PSI
down to whatever you set it to.
But what's the real application? Essentially all
that low pressure compressed air stuff will handle
150 PSI. My Sears air compressor that runs my air
tools is 150 PSI.
With some SCUBA regs, you may run into an air
volume problem with some air tools. My old Dacor
950 wasn't realy hot at running a pneumatic
cutoff tool, but my current Atomic has no problem.
Be sure the air tools are O2 clean. ;-)
Chuck
Chuck